Table 9-8: Prom Microcode Revision Level - Tandberg Data SLR7-140 PROGRAMMER Manual

BYTE BIT 7
00 Peripheral Qualifier
01 Page Code = C1h
02 RESERVED
03 Page Length = 11h
04 Main Microcode Revision Level
05
06
07
08 Main Microcode Release Status
09 Main Microcode Branch Revision Level
10
11
12
13 Main Microcode ID
14
15 DSP Microcode Revision Level
16
17
18
19 DSP Microcode Release Status
20 End Of String = 00h
Peripheral Qualifier
Peripheral Device
Type
Page Code
Page Length
Main Microcode
Revision Level
Tandberg Data
9.3.2.6. PROM Microcode Revision Level
6 5
Table 9-8: PROM Microcode Revision Level
This field will
Unsupported LUN condition exists (if an IDENTIFY message
is received, the LUN field in the Command descriptor
block will be ignored and only the LUN field in the
IDENTIFY message will be evaluated.), this field will,
however, be set to 3.
This field is normally set to 1. When an Unsupported LUN
condition exists , this field will, however, be set to
1Fh.
This field will be set to the value of the Page Code
field in the Command Descriptor Block.
This field specifies
parameters that follow the Page Length field.
Four ASCII characters showing the microcode revision
number. The two most significant bytes are incremented
by " 1" for every major code revision. The two least
significant bytes are incremented by 1 each time new
code is made.
9-11 Tandberg SLR Product Line SCSI Functional Specifications
4 3
Peripheral Device Type
normally be set
the length
Inquiry
2 1 0
to zero. When
in bytes of
an
the