Read-Write Error Recovery Page - Tandberg Data SLR7-140 PROGRAMMER Manual

BYTE BIT 7
00 PS
01 Page Length = 0Ah
02 RESERVED
03 Read Retry Count
04 RESERVED
05 RESERVED
06 RESERVED
07 RESERVED
08 Write Retry Count
09 RESERVED
10 RESERVED
11 RESERVED
Table 14-14:
PS
Page Code
Page Length
TB
EER
PER
DTE
Tandberg Data
14.3.3.

Read-Write Error Recovery Page

This page is
reporting parameters.
The page can be saved.
6 5
R Page Code = 01h
TB
Read-Write Error Recovery Page Descriptor
The Parameter Savable (PS) bit must be set to zero.
The Page Code for this page must be set to 01h.
The Page Length field must always be set to 0Ah.
The Transfer Block (TB) bit must be set to 0, it is not
changeable (an
transferred to the initiator when an unrecoverable read
error has occurred).
The enable early recovery (EER) bit must be set to 1, it
is not changeable (the Drive will always enable the use
of ECC before applying retries).
The Post Error Recovery (PER) bit must be set to 0, it
is not changeable
CONDITION status for recovered errors).
The disable transfer on error (DTE) bit must be set to
0, it is not changeable (the Drive will not terminate
the data transfer for recovered errors).
14-11 Tandberg SLR Product Line SCSI Functional Specifications
used to specify
4 3
R EER
unrecoverable data
(the Drive will
Mode Select
error recovery
2 1
PER DTE DCR
block will not
not return
and
0
be
CHECK