Table 13-9: Total Write Errors Corrected Log Parameters - Tandberg Data SLR7-140 PROGRAMMER Manual

BYTE BIT 7
n+0 Parameter Code = 0003h
n+1
n+2 DU
n+3 Parameter Length = 04h
n+4
 Write Errors Corrected Counter
n+7

Table 13-9: Total Write Errors Corrected Log Parameters

Parameter Code
DU
DS
TSD
ETC
TMC
LP
Parameter Length
Tandberg Data
Total Write Errors Corrected Log Parameters
6 5
DS TSD
The Parameter Code is set to 0003h.
A Disable Update (DU) bit set to 0 indicates that the
Drive is free to update the counter.
A DU bit set to 1 indicates that the Drive shall not
update the counter except in response to a LOG SELECT
command that specifies a new value for the counter.
The initiator may use the LOG SELECT command to set or
clear the DU bit.
The Drive will set the DU bit to 1 when the counter
reaches its maximum value (FFFFFFFFh).
The Disable Save (DS) bit is set to 1 to indicate that
the Drive does not support saving of this log parameter.
(Note: This bit can not be changed by the initiator)
The Target Save
indicate that the Drive does not provide any Drive-
defined method for saving this log parameter.
(Note: This bit can not be changed by the initiator)
An Enable Threshold
whether comparison to the threshold value is performed
or not.
The default value is 0. See the LOG SELECT command for
further description.
The Threshold Met Criteria (TMC) field is valid only if
ETC bit is 1 and
Threshold Met Criteria.
The default value is 11b. See the LOG SELECT command for
further description.
The List Parameters (LP) bit is set to 0 to indicate
that the parameter is a data counter.
(Note: This bit can not be changed by the initiator)
This field is set to 04h to indicate that the counter is
4 bytes wide.
13-10 Tandberg SLR Product Line SCSI Functional Specifications
4 3
ETC TMC
Disable (TSD) bit
Comparison
it selects one
Log Sense
2 1
R LP
is set to 1
(ETC) bit indicates
of four possible
0
to