Related Manuals for Tandberg Data BARCODE READER
Summary of Contents for Tandberg Data BARCODE READER
- Page 1 Installing or removing a Barcode Reader Table of Contents Content of the kit Required tools Installing a Barcode Reader Configuration of the Barcode Reader Barcode labels Removing a Barcode Reader Barcode Reader installation instruction Rev . 1.01 1 / 3...
- Page 2 Required tools 1 Flat-blade screwdriver; small Installing a Barcode Reader 1. The barcode reader has to be mounted on the rear side of the autoloader, see figure. 2. Power down the autoloader. 3. Remove the SCSI cable(s) and power cord from the rear panel of the autoloader and disconnect the power cord from the outlet.
- Page 3 Configuration of the Barcode Reader 1. The barcode reader is controlled through the host software. 2. The Operator Panel does not indicate that a barcode reader had been added. 3. The autoloader and host system will sense the presence of the barcode reader.
Need help?
Do you have a question about the BARCODE READER and is the answer not in the manual?
Questions and answers