Tandberg Data SLR7-140 PROGRAMMER Manual page 252

Bus Parity Error
Retries
Reselection
Retries
Tandberg Data
This field is used to specify the maximum number of
consecutive retries
detection of parity error on the data bus or reception
of an INITIATOR DETECTED ERROR message for the same
bus phase.
Legal values are 0..255, where 0 indicates that there
should be no
indicates that there is no limit to the number of
retries attempted
terminated by the Initiator).
The default (factory programmed) value is 4
This field is used to specify the maximum number of
reselection retries
reconnect to the Host. If the number of retries is
exceeded, the command will be aborted..
Legal values are any number in the range 0..255,
where values in the range 0..254 indicate a limited
number of reselection attempts and the value 255
indicates an infinite number of reselection retries.
The default (factory programmed) value is 4
14-34 Tandberg SLR Product Line SCSI Functional Specifications
of information
retries and where
(the retry
when the Drive
Mode Select
transfer upon
a value of 255
sequence must
is trying to
be