Device Configuration Page - Tandberg Data SLR7-140 PROGRAMMER Manual

BYTE BIT 7
00 PS
01 Page Length = 0Eh
02 R
03 Active Partition
04 Write Buffer Full Ratio
05 Read Buffer Empty Ratio
06 Write Delay Time
07
08 DBR
09 Gap Size
10 EOD Defined
11 Buffer Size at Early Warning
12
13
14 RESERVED
15 RESERVED
Table 14-18:
PS
Page Code
Page Length
CAP
CAF
Active Format
Active Partition
Tandberg Data
14.3.7.

Device Configuration Page

This page is
configurations.
The page can be saved.
6 5
R Page Code = 10h
CAP CAF
BIS RSMK
Device Configuration Page Descriptor
The Parameter Savable (PS) bit must be set to zero.
This field is always set to 10h.
This field must be set to 0Eh.
A Change Active Partition (CAP) bit of one indicates
that the logical partition is to be changed to the one
specified in the Active Partition field. A CAP bit of
one is only valid when using SLRtape140 to SLRtape7 or
SLR32, media. A
partition change
Partitions Within a Volume for further details.
The Change Active Format (CAF) bit must be set to 0, it
is not changeable
specified).
The Active Format field must be set to 0, it is not
changeable.
This field indicates the current partition number in use
on the medium when the CAP bit is set to one. This field
is ignored when the CAP bit is zero. The drive will
signal a CHECK CONDITION if the addressed partition does
not exist. The Active Partition is not savable. The
Drive will always be set to Partition 0 after a reset.
After a change of partition the tape will be positioned
at BOP. This will be true even if the specified Active
Partition equals the current partition.
See also section 2.3 Partitions Within a Volume for
further details.
Legal values are 0 to 35.
14-20 Tandberg SLR Product Line SCSI Functional Specifications
used to specify
4 3
Active Format
AVC SOCF
EEG SEW
CAP bit of zero
is specified. See
(no active format
Mode Select
various
2 1
RBO REW
SWP RESERVED
RFTD
indicates that
also section
change can
Drive
0
no
2.3
be