Table 13-10: Total Times Errors Processed Log Parameters - Tandberg Data SLR7-140 PROGRAMMER Manual

Write Errors
Corrected Counter
BYTE BIT 7
n+0 Parameter Code = 0004h
n+1
n+2 DU
n+3 Parameter Length = 04h
n+4 Counter ( Reserved )
n+5

Table 13-10: Total Times Errors Processed Log Parameters

Parameter Code
DU
DS
TSD
ETC
TMC
LP
Parameter Length
Counter
Tandberg Data
This counter counts re-writes during write operations.
When a block is re-written (one or more times), the
counter is incremented
performed each time capstan motor stops.
(Note: This counter counts the same events as a counter
in the parameter 0001 of this page, but it is not
savable and is smaller.)
Total Times Errors Processed Log Parameters
6 5
DS TSD
The Parameter Code is set to 0004h.
The DU always maintains its default value of 0 and can
not be changed.
The Disable Save (DS) bit is set to 1 to indicate that
the Drive does not support saving of this log parameter.
(Note: This bit can not be changed by the initiator)
The Target Save
indicate that the Drive does not provide any Drive-
defined method for saving this log parameter.
(Note: This bit can not be changed by the initiator)
An Enable Threshold Comparison (ETC) bit is always 0 and
indicates that the comparison will NOT be performed.
(Note: This bit can not be changed by the initiator)
The Threshold Met Criteria (TMC) field is not valid as
the ETC bit is 0 and can't be changed from its default
value 11b.
The List Parameters (LP) bit is set to 0 to indicate
that the parameter is a data counter.
(Note: This bit can not be changed by the initiator)
This field is set to 04h to indicate that the counter is
4 bytes wide.
This is a dummy counter that always returns 0. The
counter is implemented
compatibility.
13-11 Tandberg SLR Product Line SCSI Functional Specifications
by one. The
4 3
ETC TMC
Disable (TSD) bit
only to
Log Sense
increment(s)
2 1
R LP
is set to 1
promote ANSI SCSI-2
are
0
to