Table 9-7: Hardware Revision Levels Page - Tandberg Data SLR7-140 PROGRAMMER Manual

BYTE BIT 7
00 Peripheral Qualifier
01 Page Code = C0h
02 RESERVED
03 Page Length = 17h
04 Capstan Motor Assembly Revision Level
05
06 Step Motor Assembly Revision Level
07
08 Cartridge Manipulation Motor Module Revision Level
09
10 Sensor Assembly Revision Level
11
12 Mainboard Assembly Revision Level
13
14 Frame Module Revision Level
15
16 Head Assembly Revision Level
17
18 Top Cover Module Revision Level
19
20 Bridge Module Revision Level
21
22 Bridge Revision Level
23
24 Main Spring Module Revision Level
25
26 End Of String = 00h
Peripheral Qualifier
Peripheral Device
Type
Page Code
Page Length
Revision Levels
Tandberg Data
9.3.2.5. Hardware Revision Levels
6 5
Table 9-7: Hardware Revision Levels Page
This field will
Unsupported LUN condition exists (if an IDENTIFY message
is received, the LUN field in the Command descriptor
block will be ignored and only the LUN field in the
IDENTIFY message will be evaluated.), this field will,
however, be set to 3.
This field is normally set to 1. When an Unsupported LUN
condition exists , this field will, however, be set to
1Fh.
This field will be set to the value of the Page Code
field in the Command Descriptor Block.
This field specifies
parameters that follow the Page Length field.
These are all
revision level
hardware. The string is terminated with a zero (00h)
character.
9-10 Tandberg SLR Product Line SCSI Functional Specifications
4 3
Peripheral Device Type
normally be set
the length
two ASCII characters
of different
2 1
to zero. When
in bytes of
representing
parts of the
Inquiry
0
an
the
the
Drive's