Tapealert Page; Table 13-21: Tapealert Page; Table 13-22: Tapealert Information Log Parameters - Tandberg Data SLR7-140 PROGRAMMER Manual

BYTE BIT 7
00 RESERVED
01 RESERVED
02 Page Length = 0140h
03
04
 TapeAlert Log Parameters (64 x 5 bytes)
323
Page Code
Page Length
BYTE BIT 7
5n-1 Parameter Code = n
5n
5n+1 DU
5n+2 Parameter Length = 01h
5n+3 Value of TapeAlert Flag n

Table 13-22: TapeAlert Information Log Parameters

Parameter Code
DU
DS
TSD
ETC
Tandberg Data
13.3.5.

TapeAlert Page

The TapeAlert
parameters. Each 5-byte parameter field holds a Boolean
parameter value. If bit 0 of the Parameter Value byte is
set go 1 the value is TRUE. The remaining 7 bits are
reserved for future use and will always be set to 0.
Since the TapeAlert
control bits in
applicable, and will therefore be ignored by the drive.
6 5
Page Code = 2Eh

Table 13-21: TapeAlert Page

The Page Code for this page is 2Eh.
This field is set to 0140h indicating that a list of 64
TapeAlert flags each of length 5 bytes follows.
TapeAlert Information Log Parameters
6 5
DS TSD
The Parameter Code for each TapeAlert flag field is set
to n where n is the TapeAlert flag number. n is in the
range (1..64).
returned in ascending order of the parameter code.
A Disable Update (DU) bit set to 0 indicates that the
Drive is free to update the TapeAlert flag.
The Disable Save (DS) bit is set to 1 to indicate that
the Drive does not support saving of this log parameter.
The Target Save Disable (TSD) bit is set to 0.
The Enable Threshold Comparison (ETC) bit is set to 0 to
indicate that no threshold comparison will take place.
13-22 Tandberg SLR Product Line SCSI Functional Specifications
Page (page code
data is event
the LOG SENSE
4 3
4 3
ETC TMC
The different
Log Sense
2Eh), has 64
based, the
command are
2 1
2 1
R
parameter fields
log
page
not
0
0
LP
are