Illegal Length - Tandberg Data SLR7-140 PROGRAMMER Manual

Scsi interface functional specification
Table of Contents

Advertisement

Tandberg Data
17.3.4.

Illegal Length

When the requested transfer length does not match the
actual block length, the Drive response depends on the
state of the FIX bit, SILI bit and on the value of the
Block Size field in the MODE SELECT Block Descriptor
List.
17.3.4.1. FIX Bit Set to ZERO
If the actual block length (length of block found on the
tape) is smaller than the requested Transfer Length,
only the actual block length is transferred. If the
actual
block
length
Transfer
Length,
transferred.
SILI Bit Is Set To Zero:
If
the
SILI
bit
terminated with CHECK CONDITION status if the requested
transfer length does not match the actual block length.
The Error Code will be set to N
ILLEGAL LENGTH BLOCK READ
and Valid (VADD) bits in the sense data list will be set
to
one.
The
Information
requested Transfer Length minus the actual block length.
This
means
that
residual length. If the actual block length was smaller
than
the
specified
positive number. If the actual block length was larger
than
the
specified
negative number. Negative residues will be presented on
2's complement form. When the command has terminated,
the logical tape position will be located after the
incorrect length block (end of partition side).
SILI Bit Is Set To One:
When the SILI bit is one, the Drive will not return
CHECK CONDITION status if the only error is that the
Transfer Length exceeds the actual block length recorded
on
the
tape.
When
logical
tape
position
incorrect length block (end of partition side).
When the SILI bit is one and the only error is that the
Transfer Length is less then the actual block length
recorded
on
the
current Fixed or Variable Block mode:
17-4
Tandberg SLR Product Line SCSI Functional Specifications
is
larger
only
the
requested
is
zero,
the
READ
O ADDITIONAL SENSE INFORMATION
. The illegal length indicator (ILI)
Bytes
will
the
Information
length,
the
length,
the
the
command
will
be
tape,
the
behavior
than
the
requested
length
command
will
be
set
to
Bytes
indicate
residual
will
be
residual
will
be
has
terminated,
located
after
depends
on
Read
is
be
,
the
the
a
a
the
the
the

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SLR7-140 PROGRAMMER and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Slr7Slr50Slr60Slr75Slr100Slr140

Table of Contents