Table 23-3: Sense Key Specific Information, Invalid Fields - Tandberg Data SLR7-140 PROGRAMMER Manual

Information Bytes
Additional Sense
Length
Additional Sense
Code
Additional Sense
Code Qualifier
FRU Code
SKSV
Sense Key Specific
BYTE BIT 7
15 SKSV
16 Field Pointer
17

Table 23-3: Sense Key Specific Information, Invalid Fields

Tandberg Data
The contents of
specific and is defined within the appropriate chapter
for the command of interest. Unless otherwise specified,
this field contains
requested length minus the actual length in either bytes
or blocks, as determined by the command. Negative values
are indicated by two's complement notation.
This field specifies
bytes to follow. The Additional Sense Length is set to
14.
If the Allocation Length of the Command Descriptor Block
is too small to transfer all the additional sense bytes,
the Additional Sense Length will not be adjusted to
reflect the truncation.
This field holds
Section 23.5. and
Handling.
This field holds additional error information. See also
Section 23.5. and
Handling.
The Field Replaceable Unit (FRU) Code is set to zero (no
FRU information is available).
A Sense Key Specific Valid bit of one indicates that the
Sense Key Specific field is valid. A SKSV bit of zero
indicates that
valid.
When the Error Code is I
,
IN PARAMETER LIST
Command Descriptor Block that was invalid and caused the
CHECK CONDITION status. The format is shown in the table
below:
6 5
C/D RESERVED
C/D A Command/Data bit of one indicates
that the illegal parameter is in the
Command Descriptor Block. A C/D bit
of
parameter is in the data parameters
sent by the Initiator during the DATA
OUT phase.
BPV A Bit
indicates that the Bit Pointer field
is
indicates that the Bit Pointer field
is valid.
23-3 Tandberg SLR Product Line SCSI Functional Specifications
the Information
the difference
the number
additional error
the section
the section
the Sense Key Specific
NVALID FIELD IN
this field tells
4 3
BPV
zero indicates
Pointer Valid
not valid. A
Request Sense
Bytes is command
(residue)
of additional
information.
on General Exception
on General Exception
field is
CDB or I
NVALID FIELD
which bit in
2 1
Bit Pointer
that the illegal
bit of zero
BPV bit of one
of the
sense
See
not
the
0