Disassembling A Processor Assembly; Figure 122. Installing The Lga Terminal Cover; Figure 123. Loosening The Heat Sink Screws - Intel SR9000MK4U - Server System - 0 MB RAM Product Manual

Disassembling a Processor Assembly

Before beginning this procedure, follow all steps necessary to remove the processor from
the server system. For instructions, see
1. On the underside of the MVR, install the protective cover over on the LGA
terminal.
2. Use a Torx-15 screwdriver to loosen the four screws on the corners of the heat sink.
See letter "A" in the figure below.
3. Use a hexagonal wrench to turn the processor lock counter-clockwise to unlock the
processor socket. See letter "B" in the figure.
4. Verify that the processor lock is in the unlocked position. See letter "C".
5. Lift the processor and heat sink assembly straight up to remove it from the server.
A A
122
"Removing a Processor" on page

Figure 122. Installing the LGA Terminal Cover

A A
B

Figure 123. Loosening the Heat Sink Screws

AF001254
®
Intel Server System SR9000MK4U Product Guide
111.
C
AF001255