Installing And Removing An Optical Drive; Installing An Optical Drive; Figure 38. Locating The Optical Drive Installation Position; Figure 39. Removing The Optical Drive Filler Panel - Intel SR9000MK4U - Server System - 0 MB RAM Product Manual

Installing and Removing an Optical Drive

Installing an Optical Drive

To perform this procedure, you will first need to remove the front bezel. The steps below
will direct you to the instructions on removing the front bezel at the appropriate location
in the step sequence.
Note: Before performing the procedures in this section, turn off the system and disconnect all
power plugs.
1. Remove the front bezel. For instructions, see
page
2. Locate the optical drive location at the left side of the system. See the following
figure.
3. Push the lever on the side of the optical drive or the filler panel to remove it from
the system. Keep the filler panel for future use.
®
Intel Server System SR9000MK4U Product Guide
34.

Figure 38. Locating the Optical Drive Installation Position

Figure 39. Removing the Optical Drive Filler Panel

"Removing the Front Bezel" on
A
AF001129
51