2.4 Processor Assembly And Installation; Figure 12. Supported 2U Processor Heat Sinks - Intel M50CYP2UR Series System Integration And Service Manual

Intel® Server System M50CYP2UR Family System Integration and Service Guide

2.4 Processor Assembly and Installation

Components Required:
• 3 rd Gen Intel® Xeon® Scalable processors
• Processor carrier clip
• Standard 2U heat sink or standard 1U heat sink
• Processor tray (comes with the processor)
Required Tools and Supplies
• Anti-static wrist strap and conductive workbench pad (recommended)
• T-30 Torx* screwdriver
•
ESD Gloves
The Intel® Server System M50CYP2UR family includes two Socket-P4 LGA4189 processor sockets
compatible with the 3
rd
Two types of heat sinks are supported for the Intel® Server System M50CYP2UR family: Standard 2U heat
sink and standard 1U heat sink. The type of heat sink used depends on the system configuration and its
thermal requirements. Server systems using the GPGPU air duct must use the standard 1U heat sink.
The Intel® Server System M50CYP2UR family includes two Socket-P4 LGA4189 processor sockets
compatible with the 3 rd
A processor heat sink module (PHM) assembly and processor socket assembly are necessary to install a
processor to the server board.
socket assemblies.
Note: The following sections show the standard 2U heat sink in the figures, but the procedures described
apply to both heat sink types.
26
Gen Intel® Xeon® Scalable processor family.

Figure 12. Supported 2U Processor Heat Sinks

Gen Intel® Xeon® Scalable processor family.
Figure 13 identifies each component associated with the PHM and processor