Intel® Server System M20NTP1UR - System Integration and Service Guide
2.3 Processor Assembly and Installation
Caution: Fin edges of the processor heat sink are very sharp. Intel recommends wearing thin ESD protective
gloves when handling the Processor Heatsink Module (PHM) during the following procedures.
Components Required:
•
1 (required) or two (optional) 3
•
Processor tray (comes with the processor)
Processor carrier clip (one per processor) – Included with system
•
•
1U heat sink – Included with system
Required Tools and Supplies
•
Anti-static wrist strap, an ESD safe workbench, and other anti-ESD precautions (recommended)
ESD Gloves (recommended)
•
•
T-30 Torx* screwdriver
The processor and heat sink are pre-assembled into a single Processor Heat-sink Module (PHM) before being
installed onto the processor socket. The PHM concept reduces the risk of damaging pins within the
processor socket during the processor installation process.
A PHM assembly consists of a processor, a processor carrier clip, and the processor heat sink, as shown
below.
Figure 8. Processor Heat Sink Module (PHM) Reference Diagram
rd
Gen Intel® Xeon® Scalable processors
21