Removing A Processor - Intel SR9000MK4U - Server System - 0 MB RAM Product Manual

Removing a Processor

To perform this procedure, you first need to remove:
•
The top cover. For instructions, see
•
All installed power supplies. For instructions, see
page
•
The power supply filler panel, if one is installed. For instructions, see
Power Supply" on page
•
The power supply box. For instructions, see
page
•
Remove the hard drive backplane cover. For instructions, see
Drive Backplane Cover" on page
•
The KVM card, if it is installed. For instructions, see
page
•
All installed PCI cards. For instructions, see
•
The PCI card divider. For instructions, see
page
•
The air flow guide. For instructions, see
page
Remove these components, in order, before beginning the steps below.
The steps below do not guide you through reinstalling the components you are removing
or disconnecting in this step sequence. These steps assume you are removing the
processor to either replace it, or to access another component. After completing these
steps, continue with the steps that directed you to this section, or follow the steps under
"Installing the Processor" on page 113
®
Intel Server System SR9000MK4U Product Guide
70.
68. Follow step 2 only.
76.
89.
91.
95.
"Removing the Top Cover" on page
"Removing a Power Supply" on
"Removing the Power Supply Box" on
87.
"Removing the KVM Card" on
"Removing a PCI Card" on page
"Removing the PCI Card Divider" on
"Removing the Air Flow Guide" on
to replace your processor.
36.
"Installing a
"Removing the Hard
63.
111