Installing And Removing The Power Supply Box; Removing The Power Supply Box - Intel SR9000MK4U - Server System - 0 MB RAM Product Manual

Installing and Removing the Power Supply Box

Before beginning these steps, power down your server system and unplug all AC power
cords.
You will need to remove the power supply box to perform the following operations:
•
To install or remove the power supply support
•
To install or remove the fan box
•
To install or remove the PCI card divider
•
To install or remove the air flow guide
•
To install or remove the hard drive backplane
•
To install or remove the mounting plate
•
To install or remove a processor

Removing the Power Supply Box

To perform this procedure, you first need to remove:
•
The top cover. For instructions, see
•
All installed power supplies. For instructions, see
page
•
The power supply filler panel, if one is installed. For instructions, see
Power Supply" on page
Remove these components, in order, before beginning the steps below.
The steps below do not guide you through reinstalling the components you are removing
or disconnecting in this step sequence. These steps assume you are removing the power
supply box to either replace it, or to access another component. After completing these
steps, continue with the steps that directed you to this section, or follow the steps under
"Installing the Power Supply Box" on page 80
76
70.
68. Follow step 2 only.
"Removing the Top Cover" on page
"Removing a Power Supply" on
to replace your power supply box.
®
Intel Server System SR9000MK4U Product Guide
36.
"Installing a