Changes In Default Behavior And Syntax In Junos Os Release 10.4 For M Series, Mx Series, And T Series Routers; Class Of Service - Juniper JUNOS OS 10.4 - RELEASE NOTES REV 6 Release Note

JUNOS OS 10.4 Release Notes
Related
Documentation
Changes in Default Behavior and Syntax in Junos OS Release 10.4 for M Series, MX Series, and
T Series Routers
42
the
protected-l2circuit
interface interface-name]
protector-pe —Specify the IPv4 address of the protector PE router. The protector PE
router must have a connection to the same CE device as the protected PE router for
the egress protect LSP to function. This statement includes the following
sub-statements:
context-identifier
be used as the actual egress protection LSP. Configure the
at the
[edit protocols l2circuit neighbor neighbor-address interface interface-name
hierarchy level.
egress-protection]
[VPNs]
Local switching support for the
ignore-encapsulation-mismatch
switching. You can now configure this statement at the
local-switching interface interface-name]
2 circuit to be established even though the encapsulation configured on the CE device
interface does not match the encapsulation configured on the Layer 2 circuit interface.
Local switching allows you to configure a Layer 2 circuit entirely on the local router,
terminating the circuit on a local interface.
[VPNs]
Changes in Default Behavior and Syntax in Junos OS Release 10.4 for M Series, MX
Series, and T Series Routers on page 42
Issues in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers on page 55
Errata and Changes in Documentation for Junos OS Software Release 10.4 for M Series,
MX Series, and T Series Routers on page 77

Class of Service

Changes to the output of the
of the show interfaces queue interface-name displayed the max-queues-per-interface
information HW supported queues, as shown below:
Egress queues: 4 supported, 4 in use
The first value indicates either the default or the value specified through the
max-queues-per-interface
The first value does not change with respect to the changes to
max-queues-per-interface as before.
[Class of Service]
statement at the
[edit protocols l2circuit neighbor address
hierarchy level.
and . The
lsp lsp
ignore-encapsulation-mismatch
statement has been extended to support local
hierarchy level. This statement allows a Layer
show interfaces queue
statement. Now this is changed to HW supported queues.
statement specifies the LSP to
protector-pe statement
statement—The
[edit protocols l2circuit
command—Previously, the output
Copyright © 2011, Juniper Networks, Inc.