Changes In Default Behavior And Syntax In Junos Os Release 10.4 For M Series, Mx Series, And T Series Routers; Class Of Service; Forwarding And Sampling; Interfaces And Chassis - Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note

Changes in Default Behavior and Syntax in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers

Changes in Default Behavior and Syntax in Junos OS Release 10.4 for M Series, MX Series, and
T Series Routers
Copyright © 2010, Juniper Networks, Inc.
Errata and Changes in Documentation for Junos OS Software Release 10.4 for M Series,
MX Series, and T Series Routers on page 66

Class of Service

Changes to the output of the
of the show interfaces queue interface-name displayed the max-queues-per-interface
information HW supported queues, as shown below:
Egress queues: 4 supported, 4 in use
The first value indicates either the default or the value specified through the
max-queues-per-interface
The first value does not change with respect to the changes to
max-queues-per-interface as before.
[Class of Service]

Forwarding and Sampling

APR packet policing on TCC Ethernet interfaces—In Junos OS Release 10.4, the APR
packet policing is effective on the TCC Ethernet interfaces.
High CPU utilization of the DFWD process—You might notice a high CPU utilization
by the DFWD process if the interface lo0 is configured as part of the interface group
0.
Bridge domain naming (Layer 2 platforms)—You cannot include the slash mark (/)
in a bridge domain name at the [
level.
[Layer 2]

Interfaces and Chassis

SFC and LCC Routing Engine (RE) name changes—The SFC Routing Engine name is
changed from
RE-TXP-SFC
changed from
RE-TXP-LCC
[Software Installation and Upgrade]
Enhancement to
show oam ethernet link-fault-management detail
output of the
show oam ethernet link-fault-management detail
the following two new fields:
frame error event information
and errored frames, respectively, and are updated at every interval regardless of whether
the threshold for sending event TLVs has been crossed. Previously, the
ethernet link-fault management detail
symbols reported in TLV events transmitted since the OAM layer was reset and displays
the number of errored frames detected since the OAM layer was reset.
command—Previously, the output
show interfaces queue
statement. Now this is changed to HW supported queues.
edit bridge-domains bridge-domain-name
to , and the LCC Routing Engine name is
RE-DUO-2600
to .
RE-DUO-1800
OAM total symbol error event information
. These fields display the total number of errored symbols
command displayed only the number of errored
] hierarchy
command—The
command now includes
and OAM total
show oam
37