Pim-Dm Commands; Show Ip Dvmrp Route; Ip Pimdm (Global Config) - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

show ip dvmrp route

This command displays the multicast routing information for DVMRP.
Format
show ip dvmrp route
Modes • Privileged EXEC
• User EXEC
Term Definition
Source Address The multicast address of the source group.
Source Mask The IP Mask for the source group.
Upstream The IP address of the neighbor which is the source for the packets for a specified
Neighbor
multicast address.
Interface The interface used to receive the packets sent by the sources.
Metric The distance in hops to the source subnet. This field has a different meaning than the
Interface Metric field.
Expiry Time The expiry time in seconds, which is the time left for this route to age out.
(secs)
Up Time (secs) The time when a specified route was learnt, in seconds.

PIM-DM Commands

This section describes the commands you use to configure Protocol Independent Multicast -Dense
Mode (PIM-DM). PIM-DM is a multicast routing protocol that provides scalable inter-domain
multicast routing across the Internet, independent of the mechanisms provided by any particular
unicast routing protocol.

ip pimdm (Global Config)

This command enables the administrative mode of PIM-DM in the router.
Default disabled
Format
ip pimdm
Mode Global Config
IP Multicast Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
5-12