Network (Dhcp Pool Config) - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

network (DHCP Pool Config)

Use this command to configure the subnet number and mask for a DHCP address pool on the
server. Network-number is a valid IP address, made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified address pool. The
prefix-length is an integer from 0 to 32.
Default none
Format
network <networknumber> [{<mask> | <prefixlength>}]
Mode DHCP Pool Config
no network
This command removes the subnet number and mask.
Format
no network
Mode DHCP Pool Config
bootfile
The command specifies the name of the default boot image for a DHCP client. The <filename>
specifies the boot image file.
Format
bootfile <filename>
Mode DHCP Pool Config
no bootfile
This command deletes the boot image name.
Format
no bootfile
Mode DHCP Pool Config
Utility Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
9-45