Protocol Vlan Group All; Vlan Pvid - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

protocol vlan group all

This command adds all physical interfaces to the protocol-based VLAN identified by
<groupid>. You can associate multiple interfaces with a group, but you can only associate each
interface and protocol combination with one group. If adding an interface to a group causes any
conflicts with protocols currently associated with the group, this command will fail and the
interface(s) will not be added to the group.
Default none
Format
protocol vlan group all <groupid>
Mode Global Config
no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified by
this <groupid>.
Format
no protocol vlan group all <groupid>
Mode Global Config

vlan pvid

This command changes the VLAN ID per interface.
Default 1
Format
vlan pvid <1-4093>
Mode Interface Config
no vlan pvid
This command sets the VLAN ID per interface to 1.
Format
no vlan pvid
Mode Interface Config
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-40