Storm-Control Multicast Level; Storm-Control Multicast Rate - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

storm-control multicast level

This command configures the multicast storm recovery threshold for an interface as a perecentage
of link speed and enables multicast storm recovery mode. If the mode is enabled, multicast storm
recovery is active, and if the rate of L2 multicast traffic ingressing on an interface increases
beyond the configured threshold, the traffic will be dropped. Therefore, the rate of multicast traffic
will be limited to the configured threshold.
Default 5
Format
storm-control multicast level <0-100>
Mode Interface Config
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for an interface and
disables multicast storm recovery.
Format
no storm-control multicast level <0-100>
Mode Interface Config

storm-control multicast rate

Use this command to configure the multicast storm recovery threshold for an interface in packets
per second. If the mode is enabled, multicast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is
dropped. Therefore, the rate of multicast traffic is limited to the configured threshold.
Default 0
Format
storm-control multicast rate <0-14880000>
Mode Interface Config
no storm-control multicast rate
This command sets the multicast storm recovery threshold to the default value for an interface and
disables multicast storm recovery.
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-83