Show Ipv6 Access-Lists - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

This command specified in Interface Config mode only affects a single interface, whereas the
Global Config mode setting is applied to all interfaces. The vlan keyword is only valid in the
Global Config mode. The Interface Config mode command is only available on platforms that
support independent per-port class of service queue configuration.
Note: You should be aware that the <out> option may or may not be available,
depending on the platform.
Format
ipv6 traffic-filter <name> [vlan <vlan-id>] <in | out>[sequence <1-
4294967295>]
Modes • Global Config
• Interface Config
no ipv6 traffic-filter
This command removes an IPv6 ACL identified by <name> from the interface(s) in a given
direction.
Format
no ipv6 traffic-filter <name> [vlan <vlan-id>] in [sequence <1-
4294967295>]
Modes • Global Config
• Interface Config

show ipv6 access-lists

This command displays an IPv6 access list and all of the rules that are defined for the IPv6 ACL.
Use the [name] parameter to identify a specific IPv6 ACL to display.
Format
show ipv6 access-lists [name]
Mode Privileged EXEC
Term Definition
Rule Number The ordered rule number identifier defined within the IPv6 ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
8-47