Storm-Control Multicast - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Format
storm-control broadcast rate <0-14880000>
Mode Global Config
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all interfaces
and disables broadcast storm recovery.
Format
no storm-control broadcast rate
Mode Global Config

storm-control multicast

This command enables multicast storm recovery mode for an interface. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
multicast traffic will be limited to the configured threshold.
Default disabled
Format
storm-control multicast
Mode Interface Config
no storm-control multicast
This command disables multicast storm recovery mode for an interface.
Format
no storm-control multicast
Mode Interface Config
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-82