Show Ip Pimsm Interface - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Term Definition
Next Bootstrap Time (in hours, minutes, and seconds) in which the next bootstrap message is due from
Message In
this BSR.
Next Candidate Time (in hours, minutes, and seconds) in which the next candidate RP advertisement will
RP
be sent.
advertisement in

show ip pimsm interface

This command displays interface configuration parameters for PIM-SM on the specified interface.
If no interface is specified, all interfaces are displayed.
Format
show ip pimsm interface [<unit/slot/port>]
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
IP Address The IP address of the specified interface.
Subnet Mask The Subnet Mask for the IP address of the PIM interface.
Hello Interval The frequency at which PIM hello messages are transmitted on this interface. By default,
(secs)
the value is 30 seconds.
Join Prune The join/prune interval for the PIM-SM router. The interval is in seconds.
Interval (secs)
Neighbor Count The neighbor count for the PIM-SM interface.
Designated The IP address of the Designated Router for this interface.
Router
DR Priority The priority of the Designated Router.
BSR Border The bootstrap router border interface. Possible values are enabled or disabled.
Example: The following shows example CLI display output for the command.
(Switch) #show ip pimsm interface 1/0/3
Slot/Port...................................... 1/0/3
IP Address..................................... 41.1.1.2
Subnet Mask.................................... 255.255.255.0
Hello Interval (secs).......................... 30
Join Prune Interval (secs)..................... 60
Neighbor Count ................................ 0
IP Multicast Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
5-24