Sntp Client Mode; Sntp Client Port - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

sntp client mode

This command enables Simple Network Time Protocol (SNTP) client mode and may set the mode
to either broadcast or unicast.
Default disabled
Format
sntp client mode [broadcast | unicast]
Mode Global Config
no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Format
no sntp client mode
Mode Global Config

sntp client port

This command sets the SNTP client port id to a value from 1-65535.
Default 123
Format
sntp client port <portid>
Mode Global Config
no sntp client port
This command resets the SNTP client port back to its default value.
Format
no sntp client port
Mode Global Config
Utility Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
9-35