Ip Ospf Mtu-Ignore; Router-Id (Ospf) - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

no ip ospf transmit-delay
This command sets the default OSPF Transit Delay for the specified interface.
Format
no ip ospf transmit-delay
Mode Interface Config

ip ospf mtu-ignore

This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF
Database Description packets specify the size of the largest IP packet that can be sent without
fragmentation on the interface. When a router receives a Database Description packet, it examines
the MTU advertised by the neighbor. By default, if the MTU is larger than the router can accept,
the Database Description packet is rejected and the OSPF adjacency is not established.
Default enabled
Format
ip ospf mtu-ignore
Mode Interface Config
no ip ospf mtu-ignore
This command enables the OSPF MTU mismatch detection.
Format
no ip ospf mtu-ignore
Mode Interface Config

router-id (OSPF)

This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id. The
<ipaddress> is a configured value.
Format
router-id <ipaddress>
Mode Router OSPF Config
Routing Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
4-60