Show Ip Ospf Neighbor - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Packet Type
LS Request
LS Update
LS Acknowledgment

show ip ospf neighbor

This command displays information about OSPF neighbors. If you do not specify a neighbor IP
address, the output displays summary information in a table. If you specify an interface or tunnel,
only the information for that interface or tunnel displays. The <ip-address> is the IP address
of the neighbor, and when you specify this, detailed information about the neighbor displays. The
information below only displays if OSPF is enabled and the interface has a neighbor.
Format
show ip ospf neighbor [interface <unit/slot/port>] [<ip-address>]
Modes • Privileged EXEC
• User EXEC
If you do not specify an IP address, a table with the following columns displays for all neighbors
or the neighbor associated with the interface that you specify:
Term Definition
Router ID The 4-digit dotted-decimal number of the neighbor router.
Priority The OSPF priority for the specified interface. The priority of an interface is a priority
integer from 0 to 255. A value of '0' indicates that the router is not eligible to become the
designated router on this network.
IP Address The IP address of the neighbor.
Neighbor The interface of the local router in unit/slot/port format.
Interface
Routing Commands
Managed Switch CLI Manual, Release 8.0
Sent
1
141
40
v1.0, July 2009
Received
1
42
135
4-77