Set Igmp Groupmembership-Interval - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

no set igmp fast-leave
This command disables IGMP Snooping fast-leave admin mode on a selected interface.
Format
no set igmp fast-leave
Mode Interface Config
Format
no set igmp fast-leave <vlan_id>
Mode VLAN Config

set igmp groupmembership-interval

This command sets the IGMP Group Membership Interval time on a VLAN, one interface or all
interfaces. The Group Membership Interval time is the amount of time in seconds that a switch
waits for a report from a particular group on a particular interface before deleting the interface
from the entry. This value must be greater than the IGMPv3 Maximum Response time value. The
range is 2 to 3600 seconds.
Default 260 seconds
Format
set igmp groupmembership-interval <2-3600>
Mode • Interface Config
• Global Config
Format
set igmp groupmembership-interval <vlan_id> <2-3600>
Mode VLAN Config
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format
no set igmp groupmembership-interval
Mode • Interface Config
• Global Config
Format
no set igmp groupmembership-interval <vlan_id>
Mode VLAN Config
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-142