Set Mld Fast-Leave - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

no set mld interfacemode
Use this command to disable MLD Snooping on all interfaces.
Format
no set mld interfacemode
Mode Global Config

set mld fast-leave

Use this command to enable MLD Snooping fast-leave admin mode on a selected interface or
VLAN. Enabling fast-leave allows the switch to immediately remove the Layer 2 LAN interface
from its forwarding table entry upon receiving and MLD done message for that multicast group
without first sending out MAC-based general queries to the interface.
Note: You should enable fast-leave admin mode only on VLANs where only one host is
connected to each Layer 2 LAN port. This prevents the inadvertent dropping of the
other hosts that were connected to the same layer 2 LAN port but were still
interested in receiving multicast traffic directed to that group.
Note: Fast-leave processing is supported only with MLD version 1 hosts.
Default disabled
Format
set mld fast-leave <vlanid>
Mode • VLAN Mode
Default disabled
Format
set mld fast-leave
Mode • Interface Config
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-155