Classofservice Trust - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

The <trafficclass> values can range from 0-6, although the actual number of available
traffic classes depends on the platform.
Format
classofservice ip-dscp-mapping <ipdscp> <trafficclass>
Mode Global Config
no classofservice ip-dscp-mapping
This command maps each IP DSCP value to its default internal traffic class value.
Format
no classofservice ip-dscp-mapping
Mode Global Config

classofservice trust

This command sets the class of service trust mode of an interface. You can set the mode to trust
one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet markings. You can also set the
interface mode to untrusted. If you configure an interface to use Dot1p, the mode does not appear
in the output of the show running config command because Dot1p is the default.
Note: The classofservice trust dot1p command will not be supported in future releases of
the software because Dot1p is the default value. Use the no classofservice trust
command to set the mode to the default value.
Default dot1p
Format
classofservice trust {dot1p | ip-dscp | ip-precedence | untrusted}
Modes • Global Config
• Interface Config
no classofservice trust
This command sets the interface mode to the default value.
Format
no classofservice trust
Modes • Global Config
• Interface Config
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
8-3