About This Manual; Audience; About Managed Switch Software - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Layer-3 managed stackable switch version 8.0

Hide thumbs Also See for GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch:

Table of Contents

This document describes command-line interface (CLI) commands you use to view and configure

7300S Series Stackable Switch software. You can access the CLI by using a direct connection to

the serial port or by using telnet or SSH over a remote network connection.

Note: This document contains both standalone and stacking commands.

This document is for system administrators who configure and operate switches using 7300S

Series Stackable Switch software. It provides an understanding of the configuration options of the

This document assumes that the reader has an understanding of the software base and has read the

appropriate specification for the relevant networking device platform. It also assumes that the

reader has a basic knowledge of Ethernet and networking concepts.

The Managed Switch software has two purposes:

Assist attached hardware in switching frames, based on Layer 2, 3, or 4 information contained

in the frames.

Provide a complete device management portfolio to the network administrator.

About This Manual

v1.0, July 2009

Table of Contents