Table of Contents
Advertisement
Chapter 9
Managing Subscribers
Options
The following options are available:
•
•
Configuring the Behavior of the SCE Platform in Case of Failure of the SM
Options
The following options are available:
•
•
To specify the action that the SCE platform will perform if the SCE-SM connection fails, use this
command.
From the SCE(config if)# prompt, type subscriber sm-connection-failure action
Step 1
[force-failure|none|remove-mappings|shut] and press Enter.
To specify that the system operational-status of the SCE platform should be 'warning' if the SCE-SM
connection fails, use this command.
Step 1
From the SCE(config if)# prompt, type subscriber sm-connection-failure warning and press Enter.
OL-7827-12
action — the action to take in case of failure of the SCE platform/SM connection
force-failure — force failure of SCE platform. The SCE platform then acts according to the
–
behavior configured for the failure state.
–
remove-mappings — remove all current subscriber mappings.
shut — the SCE platform shuts down and quits providing service.
–
none (default) — take no action.
–
interval — the time interval, in minutes, after which the connection is timed out
action—The specified action will be performed in case of loss of connection between the SCE
platform and the SM.
Possible actions are:
–
force-failure — Force failure of SCE platform. The SCE platform then acts according to the
behavior configured for the failure state.
–
remove-mappings — Remove all current subscriber mappings.
–
shut — The SCE platform shuts down and quits providing service.
–
none (default) — Take no action.
warning—The system operational-status of the SCE platform should be 'warning' in case of loss of
connection between the SCE platform and the SM. No action is taken.
Configuring the SCE Platform/SM Connection
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
9-41
Advertisement
Table of Contents
