Table of Contents
Advertisement
Chapter 8
Raw Data Formatting: The RDR Formatter and NetFlow Exporting
How to Configure a DSCP Value for NetFlow
Options
The following option is available:
•
Step 1
From the SCE(config)# prompt, type
Enter.
Configures the DSCP value for NetFlow exporting support.
How to Configure the Template Refresh Interval
Options
The following options are available:
•
•
•
From the SCE(config)# prompt, type
Step 1
protocol NetFlowV9 template data timeout
Sets the template refresh interval.
Configuring Dynamic Mapping of RDRs to Categories
•
Dynamic configuration of RDRs to multiple categories is supported.
Each RDR tag has a list of categories. The default category is the one that was assigned when application
was loaded.
The configuration of categories to RDR tags is done by adding and removing mappings. A user can add
a mapping of an RDR tag to a category and can remove a mapping, including the default mapping. If all
categories are removed from a tag, the tag is ignored as long as it remains with no mapped categories.
The user must provide the RDR tag ID and the category number to add or remove. The configuration is
saved as part of the application configuration.
OL-7827-12
dscp-value — DSCP value to be assigned to he NetFlow packets over all destinations (0-63 in HEX
format)
ip-address — the destination IP address.
port-number — the destination port number
timeout-value — the frequency of exporting the template records in seconds (1 – 86400.)
How to Configuring Mappings, page 8-16
Configuring Dynamic Mapping of RDRs to Categories
rdr-formatter protocol NetFlowV9 dscp
rdr-formatter destination
timeout-value, and press Enter.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
dscp-value, and press
ip-address
port-number
port
8-15
Advertisement
Table of Contents
