Table of Contents
Advertisement
Chapter 9
Managing Subscribers
Subscriber Rules for TIRs
The number of reserved rules for potential TIRs is configurable, and is at the expense of explicit
subscriber rules. The total number of subscriber rules available is approximately 8000.
•
•
•
How to Reserve Rules for TIRs
Use these commands to reserve rules for TIRs and to restore default subscriber rule allocation.
Options
The following options are available:
•
From the SCE(config if)# prompt, type
Step 1
Enter
Allocates the specified number of rules for TIRs, decreasing the number of explicit subscriber rules
available.
To restore all rules as explicit subscriber rules, with no rules reserved for TIRs (default), use the
following command:
•
How to Configure TIRs
•
•
•
OL-7827-12
The maximum number of allowed reserved rules is 4096. The remaining rules are reserved for
explicit subscriber mappings usage (used by the SCE platform to enable the legacy internal OS
allocation of subscribers to traffic processors).
By default 0 (zero) rules are reserved for TIRs.
Updating this configuration is a major system event and can only be performed when no subscriber
mappings or TIRs are configured.
#rules — number of subscriber rules to be reserved for TIRs
default subscriber TP-mappings
Options, page 9-32
How to Create or Update a TIR, page 9-32
How to update a TIR even if subscriber mappings exist, page 9-32
subscriber TP-mappings max-TP-IP-ranges
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Subscriber Traffic Processor IP Ranges
#rules and press
9-31
Advertisement
Table of Contents
