Table of Contents
Advertisement
Chapter 3
Operations
How to Create a Backup Configuration File
At the SCE# prompt, type copy startup-config backup-file and press Enter.
Step 1
Backs up the startup-config file to the specified file.
How to Upload a Backup Configuration File
At the SCE# prompt, type copy backup-file startup-config and press Enter.
Step 1
Copying a Backup Configuration File to a Different SCE Platform: Example
This example shows how to copy the configuration from one SCE platform to another.
On the first SCE platform, enter the following command:
SCE1#copy startup-config ftp://adminuser:mypassword@10.10.10.10/c:/config/bckupcfg.txt
SCE1#
On the second SCE platform, enter the following command:
SCE2#copy ftp://adminuser:mypassword@10.10.10.10/c:/config/bckupcfg.txt startup-config
SCE2#
Upgrading the SCE Platform Firmware
Cisco distributes upgrades to the software and firmware on the SCE platform. Cisco distributes upgrade
software as a file with the extension.pkg that is installed directly from the ftp site without being copied
to the disk. This procedure walks you through installation and rebooting of the SCE platform with the
new firmware.
At the command prompt, type configure and press Enter.
Step 1
Enters Global Configuration mode.
Type boot system ftp://user:password @host /drive:dir /seNum.pkg, where seNum.pkg is the file name
Step 2
on the ftp site.
The boot command verifies that the package is a legal, appropriate update for the SCE platform and that
the file was not corrupted. It does not perform an upgrade, but does keep in the system memory that a
pkg file is available.
Type exit.
Step 3
Exits Global Configuration mode.
Type copy running-config startup-config.
Step 4
This command re-verifies that the package is valid, and extracts the upgrade to the Flash file system.
The system notifies you that it is performing the extraction as follows:
Backing–up configuration file...
Writing configuration file...
Extracting new system image...
Extracted OK.
OL-7827-12
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Upgrading the SCE Platform Firmware
3-7
Advertisement
Table of Contents
