Table of Contents
Advertisement
Configuring Domain Name Server (DNS) Settings
How to Enable DNS Lookup
From the SCE(config)# prompt, type ip domain-lookup and press Enter.
Step 1
Enables DNS lookup.
How to Disable DNS Lookup
From the SCE(config)# prompt, type no ip domain-lookup and press Enter.
Step 1
Configuring Name Servers
•
•
•
•
Options
The following options are available:
•
How to Define Domain Name Servers
Use this command to specify the address of one or more name servers to use for name and address
resolution.
Step 1
From the SCE(config)# prompt, type ip name-server server-address1 [server-address2
[server-address3]] and press Enter.
Defines the servers at the specified addresses as domain name servers.
Defining Domain Name Servers: Example
The following example shows how to configure the two name server (DNS) IP addresses.
SCE(config)#ip name-server 10.1.1.60 10.1.1.61
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
5-68
Options, page 5-68
How to Define Domain Name Servers, page 5-68
How to Remove a Domain Name Server, page 5-69
How to Remove All Domain Name Servers, page 5-69
server-ip-address — The IP address of the domain name server. You can define more than one DNS
server (server-ip-address1, server-ip-address2, server-ip-address3)
Chapter 5
Configuring the Management Interface and Security
OL-7827-12
Advertisement
Table of Contents
Need help?
Do you have a question about the SCE2020-4XGBE-SM and is the answer not in the manual?
Questions and answers