Table of Contents
Advertisement
Chapter 5
Configuring the Management Interface and Security
Options
The following options are available:
•
•
From the SCE# prompt, type show ip route prefix mask and press Enter.
Step 1
Displays the routing table for the specified subnet (prefix/mask).
Displaying the IP Routing Table for a Specified Subnet: Example
This example shows how to display the routing table for a specified subnet.
SCE#show ip route 10.1.60.0 255.255.255.0
|
|-----------------|-----------------|-----------------|
|
sce#
IP Advertising
•
•
IP advertising is the act of periodically sending ping requests to a configured address at configured
intervals. This maintains the SCE platform IP/MAC addresses in the memory of adaptive network
elements, such as switches, even during a long period of inactivity.
The following commands are relevant to IP advertising:
•
•
•
•
•
•
•
•
Configuring IP Advertising
To configure IP advertising, you must first enable IP advertising. You may then specify a destination
address to which the ping request is to be sent and/or the frequency of the ping requests (interval). If no
destination or interval is explicitly configured, the default values are assumed.
OL-7827-12
prefix — IP address of the routing entry, in dotted notation.
mask — The relevant subnet mask, in dotted notation
prefix
|
mask
10.1.60.0 |
255.255.255.0 |
Configuring IP Advertising, page 5-55
How to Display the Current IP Advertising Configuration, page 5-56
[no] ip advertising
ip advertising destination
ip advertising interval
default ip advertising destination
default ip advertising interval
show ip advertising
show ip advertising destination
show ip advertising interval
|
next hop
|
10.1.1.5 |
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
IP Configuration
5-55
Advertisement
Table of Contents
