Table of Contents
Advertisement
Chapter 12
Value Added Services (VAS) Traffic Forwarding
From the SCA BB console, remove all the VAS table associations to packages and apply the changed
Step 1
policy.
From the SCE(config if)# prompt, type shutdown and press Enter.
Step 2
Shuts down the line card.
From the SCE(config if)# prompt, type no VAS-traffic-forwarding and press Enter.
Step 3
Disables VAS traffic forwarding.
From the SCE(config if)# prompt, type no shutdown and press Enter.
Step 4
Re-enables the line card.
How to Configure the VAS Traffic Link
•
•
•
By default, the VAS traffic is transmitted on Link 1. If the VAS servers are connected on Link 0, you
must configure the VAS traffic link to Link 0.
To configure the link for VAS over 10G, see
Note
The VAS traffic link should be in Forwarding mode.
Options
The following option is available:
•
How to Select the Link for VAS Traffic
From the SCE(config if)# prompt, type VAS-traffic-forwarding traffic-link {link-0|link-1} and press
Step 1
Enter.
How to Revert to the Default Link for VAS Traffic
From the SCE(config if)# prompt, type no VAS-traffic-forwarding traffic-link and press Enter.
Step 1
OL-7827-12
Options, page 12-19
How to Select the Link for VAS Traffic, page 12-19
How to Revert to the Default Link for VAS Traffic, page 12-19
VAS traffic-link {link-0|link-1} — The link number on which to transmit VAS traffic
Default — Link 1
–
VAS over 10G, page
12-32).
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Configuring VAS Traffic Forwarding
12-19
Advertisement
Table of Contents
