Procedure For Adding A System Board; Checking The Delivered Items; Mounting The Added Options - Cisco C880 M4 Service Manual

SET0102000

1.2 Procedure for Adding a System Board

SET0102010

1.2.1 Checking the delivered items

(1) Check the delivered items by confirming the following.
1. The types and quantities of delivered options match those written on the order sheet.
2. The delivered items match those listed in the List of Accessories.
3. All cabinets are free of any abnormalities such as scratches, dents, or dirt.
4. The specifications and version level of units delivered separately due to delivery considerations
are available for the target functions.
SET0102020

1.2.2 Mounting the added options

Use the following steps to mount the added options.
ANNT) Confirm the quantities and installation locations with a system administrator.
ANNT) If you start the work with the main unit powered off, turn on the AC power and mount the added
options.
(1) Connect the FST. See Appendix B.2.1, "FST Setup and Connection (APP0202010)".
(2) Login to the Web-UI.
Table 1.2.2 lists the values to be set to log in to Web-UI.
See Appendix B.3.1, "Login (APP0203010)".
Item
URL
Username
Password
(3) Enter Maintenance Mode.
See Appendix B.1.1, "Enabling maintenance Mode (APP0201010)".
(4) Confirm the numbers and mounting locations of the options.
(5) Remove the dummy system board, and install the system board.
See Appendix C.2, "System Board (APP0302000)".
(6) Wait about 1 minute and check that [Alarm] LED of the system board is not on after adding a
system board.
(7) Change Maintenance Mode disabled. See Appendix B.1.2," Disabling maintenance mode
(APP0201020)".
(8) Click [Maintenance] on the navigation bar.
→ The window shown in Figure 1.2.2-1 appears.
Table 1.2.2
Setting values
http://<Maintenance IP Address>:<http port#> or
https://<Maintenance IP Address>:<https port#>
This depends on the system configuration.
http port#:Default(8081)
https port#:Default(432)
Account username
Account password
11
CA92344-0577-01