Table of Contents
Advertisement
VAS over 10G
VAS Over 10G Sample Configuration
Following is a sample illustrating the steps in configuring the VAS over 10G solution.
Command
Step 1
SCE#configure
SCE(config)# interface LineCard 0
Step 2
SCE(config if)#VAS-traffic-forwarding health-check
topology MGSCP
Step 3
SCE(config if)# VAS-traffic-forwarding health-check
ip-address source 192.168.100.0:0xffffff00 destination
192.168.101.0
Step 4
SCE(config if)# VAS-traffic-forwarding traffic-link
auto-select
Step 5
SCE(config if)# VAS-traffic-forwarding traffic-link
auto-select link-switch-delay 240
Step 6
SCE(config if)# #VAS-traffic-forwarding traffic-link
auto-select initial-selection link-0
Step 7
SCE(config if)#VAS-traffic-forwarding VAS server-id 0
VLAN 600
SCE(config if)#VAS-traffic-forwarding VAS server-id 1
VLAN 601
SCE(config if)#VAS-traffic-forwarding VAS server-id 2
VLAN 602
SCE(config if)#VAS-traffic-forwarding VAS server-id 3
VLAN 603
Step 8
SCE(config if)#VAS-traffic-forwarding VAS server-group
0 server-id 0
SCE(config if)#VAS-traffic-forwarding VAS server-group
0 server-id 1
SCE(config if)#VAS-traffic-forwarding VAS server-group
1 server-id 2
SCE(config if)#VAS-traffic-forwarding VAS server-group
1 server-id 3
Step 9
SCE(config if)#VAS-traffic-forwarding
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
12-46
Chapter 12
Value Added Services (VAS) Traffic Forwarding
Purpose
Enters LineCard Interface configuration mode
Sets the VAS health-check to MGSCP mode.
Set the VAS health-check source and destination IP
addresses
(source = 192.168.100.0/24 and destination =
192.168.101.0)
Set the VAS traffic link to auto-select so in case of a
failure in any of the VAS servers group, the VAS
traffic link will be automatically switched.
Configure the link switch delay (four minutes).
The delay will be applied only if there was no
successful health check on the current link.
Set link-0 to be used as the initial VAS traffic link in
auto-select mode.
Assign VAS servers 0-3 to VLAN 600-603
respectively.
Map VAS servers 0-1 and 2-3 to server groups 0 and
1 respectively, allowing server redundancy within
each group.
Set the SCE platform to forward VAS traffic (enable
VAS traffic forwarding).
OL-7827-12
Advertisement
Table of Contents
