Table of Contents
Advertisement
Configuring the SCE Platform/SM Connection
How to Set the Aging Timeout Period for Introduced Subscribers
Options
The following option is available:
•
From the SCE(config if)# prompt, type
Step 1
press Enter.
How to Display Aging for Anonymous Group Subscribers
From the SCE> prompt, type
Step 1
Enter.
How to Display Aging for Introduced Subscribers
From the SCE> prompt, type
Step 1
Enter.
Configuring the SCE Platform/SM Connection
•
•
•
The user can configure the behavior of the SCE platform in case of failure of the Subscriber Manager
(SM):
•
•
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
9-40
aging-time — the time interval, in minutes, after which an inactive subscriber sill be aged.
show interface linecard 0 subscriber aging anonymous
show interface linecard 0 subscriber aging introduced
Options, page 9-41
Configuring the Behavior of the SCE Platform in Case of Failure of the SM, page 9-41
Configuring the SM-SCE Platform Connection Timeout, page 9-42
If SM functionality is critical to the operation of the system — configure the desired behavior of the
SCE platform if any loss of connection with the SM (may be due either to failure of the SM or failure
of the connection itself).
If SM functionality is not critical to the operation of the system — no action needs to be configured.
In this case you can specify that the system operational-status of the SCE platform should be
'warning' when the link is down.
no subscriber aging introduced timeout
Chapter 9
Managing Subscribers
aging-time and
and press
and press
OL-7827-12
Advertisement
Table of Contents
