Table of Contents
Advertisement
Configuring Subscriber Aging
How to Restore the Configured Capacity Option
From the SCE(config if)# prompt, type subscriber capacity-options enable and press Enter.
Step 1
Load the new application.
Step 2
How to Monitor the Maximum Number of Subscribers
Use this command to see the configured maximum number of subscribers and whether the capacity
options are in effect or have been overridden.
From the SCE> prompt, type show interface linecard 0 subscriber max-subscribers and press Enter.
Step 1
Configuring Subscriber Aging
•
•
•
•
•
•
•
•
As explained previously
when no traffic sessions assigned to it have been detected for a certain amount of time. Aging may be
enabled or disabled, and the aging timeout period (in minutes) can be specified.
Aging can be configured separately for introduced subscribers and for anonymous subscribers.
Use the following commands to configure and monitor aging.
•
•
•
How to Enable Aging for Anonymous Group Subscribers
Step 1
From the SCE(config if)# prompt, type
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
9-38
How to Enable Aging for Anonymous Group Subscribers, page 9-38
How to Enable Aging for Introduced Subscribers, page 9-39
How to Disable Aging for Anonymous Group Subscribers, page 9-39
How to Disable Aging for Introduced Subscribers, page 9-39
How to Set the Aging Timeout Period for Anonymous Group Subscribers, page 9-39
How to Set the Aging Timeout Period for Introduced Subscribers, page 9-40
How to Display Aging for Anonymous Group Subscribers, page 9-40
How to Display Aging for Introduced Subscribers, page 9-40
(Aging Subscribers, page
[no] subscriber aging
subscriber aging timeout
show interface linecard 0 subscriber aging
9-5, aging is the automatic removal of a subscriber
subscriber aging anonymous
Chapter 9
Managing Subscribers
and press Enter.
OL-7827-12
Advertisement
Table of Contents
