Table of Contents
Advertisement
Configuring the SCE Platform/SM Connection
Options
The following options are available:
•
•
The default value is operational.
From the SCE(config)# prompt, type failure-recovery operation-mode operational|non-operational
Step 1
and press Enter.
Specify the desired failure recovery mode.
Configure the Failure Recovery Mode: Examples
•
•
Example 1
This example sets the system to boot as non-operational after a failure.
SCE(config)#failure-recovery operation-mode non-operational
Example 2
This example sets the system to the default failure recovery mode.
SCE(config)# default failure-recovery operation-mode
Configuring the SCE Platform/SM Connection
•
•
The user can configure the behavior of the SCE platform in case of failure of the Subscriber Manager
(SM):
•
•
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
7-10
operational — after failure, the system will return to operational mode.
non-operational — after failure, the system will remain not operational.
Example 1, page 7-10
Example 2, page 7-10
Configuring the Behavior of the SCE Platform in Case of Failure of the SM, page 7-11
Configuring the SM-SCE Platform Connection Timeout, page 7-11
If SM functionality is critical to the operation of the system — configure the desired behavior of the
SCE platform if any loss of connection with the SM (may be due either to failure of the SM or failure
of the connection itself).
If SM functionality is not critical to the operation of the system — no action needs to be configured.
Chapter 7
Configuring the Connection
OL-7827-12
Advertisement
Table of Contents
