Table of Contents
Advertisement
Rebooting and Shutting Down the SCE Platform
Shutting Down the SCE Platform
Shutting down the SCE platform is required before turning the power off. This helps to ensure that
non-volatile memory devices in the SCE platform are properly flushed in an orderly manner.
Note
When the SCE platform restarts, it loads the startup configuration, so all changes made in the running
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in.
Connect to the serial console port (The CON connector on the SCE platform front panel, 9600 baud).
Step 1
Provides connection to a local terminal for restarting the SCE platform.
Step 2
From the SCE# prompt, type reload shutdown and press Enter.
A confirmation message appears.
Type Y to confirm the shutdown request and press Enter.
Step 3
Performs the shutdown operation.
Shutting Down the SCE Platform: Examples
The following example shows the commands for system shutdown.
SCE#reload shutdown
You are about to shut down the system.
The only way to resume system operation after this
is to cycle the power off, and then back on.
Continue?
y
IT IS NOW SAFE TO TURN THE POWER OFF.
Note
Since the SCE platform can recover from the power-down state only by being physically turned off (or
cycling the power), this command can only be executed from the serial CLI console. This limitation
helps prevent situations in which a user issues this command from a Telnet session, and then realizes that
he or she has no physical access to the SCE platform.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
3-16
Saving the Configuration Settings, page 3-4
Chapter 3
Operations
OL-7827-12
Advertisement
Table of Contents
