Table of Contents
Advertisement
Chapter 9
Managing Subscribers
Use these commands to remove existing TIRs and subscriber mappings. You can perform the following
operations:
•
•
•
•
As with updating a TIR, by default, if subscriber mappings already exist for the specified IP range, the
command will fail. However, you can specify that any existing subscriber mappings in the IP range
should be removed (remove-subscriber-mappings keyword). In this case the command will execute even
if subscriber mappings exist.
How to Remove a Specified TIR
From the SCE(config if)# prompt, type
Step 1
[remove-subscriber-mappings] and press Enter.
If subscriber mappings exist for this IP range, the command will fail. Specify
remove-subscriber-mappings to remove any existing subscriber mappings for this IP range, and the
command will execute successfully.
How to Remove All TIRs
Step 1
From the SCE(config if)# prompt, type
[remove-subscriber-mappings] and press Enter.
If subscriber mappings exist for this IP range, the command will fail. Specify
remove-subscriber-mappings to remove any existing subscriber mappings for this IP range, and the
command will execute successfully.
How to Remove Mappings from a Specified TIR
From the SCE(config if)# prompt, type
Step 1
tir-name and press Enter.
The remove-subscriber-mappings option is not applicable to this command.
OL-7827-12
Remove a specified TIR
Remove all TIRs
Remove all subscriber mappings assigned to a specified TIR
Remove all subscriber mappings assigned to a specified IP range
no subscriber TP-IP-range name
no subscriber TP-IP-range all
no subscriber mappings included-in TP-IP-range name
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Subscriber Traffic Processor IP Ranges
tir-name
9-33
Advertisement
Table of Contents
