Application And Subscriber Groups - Cisco SCE2020-4XGBE-SM Configuration Manual

pcube Enterprise MIB

Application and Subscriber groups

These groups allow the operator to view information exposed by the application. In essence, these groups
contain tables that allow access to viewables and tuneables defined in the installed SML application.
This mechanism is general, and does not require specific adjustments of the SCOS platform for an
application. Any installed application can define variables that would then automatically be accessible
through the application or subscriber groups.
•
•
The Application Group
The application group contains information about the application itself. It also contains two tables:
•
•
•
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
B-4
The Application Group, page B-4
The Subscriber Group, page B-5
appPropertiesTable:
Contains a list of properties of the application. These properties are SML viewables and tuneables
that are defined in global scope. Each property has a name and a type (both are strings).
This table is updated when the application is installed, and has read-only access. It is therefore
managed by the agent (the SCOS).
appPropertiesValueTable:
Contains information about the application properties that appear in the appPropertiesTable,
described above. For each such property, a value is available in one or more formats, as appropriate:
– String
Integer
–
64-bit Integer.
–
This table is a read-write table, which uses the row-status mechanism. With this mechanism it is
possible for a management station to add rows to an SNMP table in an pseudo-atomic way. The
RowStatus type is defined in SNMPv2-SMI.
This table is cleared when an application is unloaded, or when the system resets. The manager may
add rows to the table after the system starts, with properties taken from the appPropertiesTable, and
then it is possible to poll these variables for their values. It is the manager's responsibility to read
the value in the correct format (according to the "type" field in the appPropertiesTable ).
Note that the values cannot be changed through SNMP. Tuneables and Viewables are the same in
this respect, they can only be viewed.
Note as well that all the properties in the application group are global properties.
Appendix B Proprietary MIB Reference
OL-7827-12