Table of Contents
Advertisement
Configuring and Managing the SNMP Interface
SCE platform can be configured to generate either SNMPv1 style or SNMPv2c style notifications. By
default, the SCE platforms sends SNMPv1 notifications.
Following are some sample procedures illustrating how to do the following:
•
•
•
•
•
How to Define SNMP Hosts
Use this command to define the hosts that will receive notifications from the SCE platform.
•
•
•
•
Options
The following options are available:
•
•
•
How to Configure the SCE Platform to Send Notifications to a Host (NMS)
Step 1
At the SCE(config)# prompt, type snmp-server host ip-address community-string and press Enter.
If the version is not specified, SNMPv1 is assumed.
Only one host can be specified per command. To define multiple hosts, execute one command for each
host.
Configuring the SCE Platform to Send Notifications to Multiple Hosts: Example
The following example shows how to configure the SCE platform to send SNMPv1 notifications to
several hosts.
SCE(config)#snmp-server host 10.10.10.10 mycommunity
SCE(config)#snmp-server host 20.20.20.20 mycommunity
SCE(config)#snmp-server host 30.30.30.30 mycommunity
SCE(config)#snmp-server host 40.40.40.40 mycommunity
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
5-44
Configure hosts (NMS) to which the SNMP agent should send notifications
Remove/disable a host (NMS) from receiving notifications
Enable the SNMP agent to send authentication-failure notifications
Enable the SNMP agent to send enterprise notifications
Reset all notifications to the default setting
Options, page 5-44
How to Configure the SCE Platform to Send Notifications to a Host (NMS), page 5-44
How to Configure the SCE Platform to Stop Sending Notifications to a Host, page 5-45
How to Configure SNMP Traps, page 5-45
ip-address — the IP address of the SNMP server host
community-string — a security string that identifies a community of managers who are permitted
to access the SNMP server
version — SNMP version running in the system. Can be set to 1 or 2c.
–
Default — 1 (SNMPv1)
Chapter 5
Configuring the Management Interface and Security
OL-7827-12
Advertisement
Table of Contents
