Cisco SCE2020-4XGBE-SM Configuration Manual page 217

Software configuration guide
Table of Contents

Advertisement

Chapter 8
Raw Data Formatting: The RDR Formatter and NetFlow Exporting
From the SCE(config)# prompt, type
Step 1
category [name
category-name
number
category-number
Defines the destination and assigns categories with optional priorities.
Configuring the Data Destinations with Categories: Examples
Example 1, page 8-9
Example 2, page 8-10
Example 3, page 8-10
Example 4, page 8-11
Example 5, page 8-12
Example 1
The following example defines a name for one category, and then configures two destinations, assigning
each to a different category (see
The data from category 1 goes to the first destination, so a high priority was assigned to that category in
the first destination, and no priority in the second.
Since all data from category 2 (prepaid) goes to the second destination, the priority assigned to category
2 is assigned only to the second destination and not to the first.
Figure 8-3
RDR Formatter
Note that if there is a loss of connection to either destination, transmission of data of the relevant
category is interrupted until the connection is re-established. There is no redundant connection defined
for either category.
SCE(config)# rdr-formatter category number 2 name prepaid
SCE(config)# rdr-formatter destination 10.1.1.205 port 33000 category number 1 priority 90
protocol RdrV1 transport tcp
SCE(config)# rdr-formatter destination 10.1.1.206 port 33000 category name prepaid
protocol RdrV1 transport tcp
OL-7827-12
category-name
category-number
| number
category-number
] [priority
priority ]]
] [priority
Configuring Destinations: Two Categories and Two Destinations
SCE platform
Category 1
"Prepaid"
rdr-formatter destination
category-number
| number
priority ]] [
] [priority
priority ]] [
category [name
protocol
protocol
Figure
8-3).
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Configuring Data Destinations and Categories
ip-address
portnumber
port
priority ] [
] [priority
category [name
category-name
category [name
category-name
| number
transport
and press Enter.
[transport
],
Destination 1
Destination 2
|
8-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sce 2000Sce 1000

Table of Contents